Dot1X - Huawei Quidway S8500 Series Command Manual

Command Manual – Security
Quidway S8500 Series Routing Switches
Total current used 802.1x resource
number
Ethernet3/1/1 is link-up
802.1X protocol is disabled
Proxy trap checker is disabled
Proxy logoff checker is disabled
The port is a(n) authenticator
Authenticate Mode is auto
Port Control Type is Mac-based
Max on-line user number
...

1.1.3 dot1x

Syntax
dot1x [ interface interface-list ]
undo dot1x [ interface interface-list ]
View
System view, Ethernet port view
Parameter
interface-list:
=interface-type interface-number [ to interface-type interface-number ] &<1-10>.
interface-type means the interface type, interface-number is the interface number.
Refer to command parameters in the "Port" section in the manual for the respective
meanings and value ranges of them. The interface number after the key word to should
be no smaller than the interface number before to. &<1-10> in the command means
that the preceding parameter can be entered up to 10 times.
Description
Use the dot1x command to enable 802.1x on the specified port or globally (i.e., on the
current device).
Use the undo dot1x command to disable the 802.1x on the specified port or globally.
Field
Ethernet interface
Huawei Technologies Proprietary
1-4
Chapter 1 802.1x Configuration Commands
Description
Number of access users currently on line
The state of Ethernet 2/1/1 is Up.
802.1X protocol is disabled on the port
The port prohibits the access of users
who log on through a proxy
The port acts as authenticator
The authentication mode of the port is
Auto
The port control type is Mac-based,
namely, authentication of access users is
implemented based on the MAC address.
The maximum number of on-line users
Omitted
list expressed in the format
interface-list