Ip Pool - Huawei Quidway S8500 Series Command Manual

Command Manual – Security
Quidway S8500 Series Routing Switches
Because a user template only works in one ISP domain, it is necessary to configure
user template attributes for users from different ISP domain respectively.
Related command: domain.
Example
# Enable the user in the current ISP domain, huawei163.net, to use the Idle-cut
attribute specified in the user template (that is, enabling the user to use the Idle-cut
function). The maximum idle time is 50 minutes and the minimum data traffic is 500
bytes.
[Quidway-isp-huawei163.net] idle-cut enable 50 500

2.1.10 ip pool

Syntax
ip pool pool-number low-ip-address [ high-ip-address ]
undo ip pool pool-number
View
System view, ISP domain view
Parameter
pool-number: Address pool number ranging from 0 to 99.
low-ip-address and high-ip-address: Two ends of the IP address pool. The number of IP
addresses in an address pool cannot exceed 1024. If you do not provide the
high-ip-address argument, then the address pool only contains the one specified by the
low-ip-address argument.
Description
Use the ip pool command to create a local IP address pool for PPP users.
Use the undo ip pool command to remove a specified local address pool.
By default, no local IP address pool is created.
After creating an IP address pool in system view, you can use the remote address
command to assign IP addresses in it to PPP users.
The IP addresses in an IP address pool created in ISP domain view are mainly for PPP
users of the ISP domain. This kind of IP address pools is suitable for ports with many
PPP users connected to them and the available IP address these ports provide are not
sufficient. For example, a PPPoE-enabled Ethernet port can accommodate up to 4095
users, but its Virtual Template can have only one IP address pool configured, which
contains up to only 1024 IP address. By configuring an ISP domain address pool for the
Chapter 2 AAA and RADIUS/HWTACACS Protocol
Huawei Technologies Proprietary
2-11
Configuration Commands