Mpls Ldp Remote-Peer - Huawei Quidway S8500 Series Command Manual

Command Manual – MPLS
Quidway S8500 Series Routing Switches
Use the undo mpls ldp path-vectors command to restore the default maximum value
of path vector.
By default, pv-number is 32.
This command should be configured before LDP is enabled on all interfaces. Its value,
which depends on actual networking situation, determines the loop detection speed
during LSP creation
Related command: mpls ldp loop-detection and mps ldp hops-count.
Example
# Set the maximum value of path vector to 23
<Quidway>system-view
[Quidway] mpls ldp path-vectors 23
# Restore the default maximum value of path vector.
[Quidway] undo mpls ldp path-vectors

1.2.15 mpls ldp remote-peer

Syntax
mpls ldp remote-peer index
undo mpls ldp remote-peer index
View
System view or remote-peer view
Parameter
index: Index that identifies a remote peer entity, ranging from 0 to 99.
Description
Use the mpls ldp remote-peer command to create a Remote-peer entity and enter
remote-peer view.
Use the undo mpls ldp remote-peer command to delete a Remote-peer entity.
You can use this command to create a Remote-peer and accordingly create a
Remote-session.
Related command: remote-ip.
Example
# Create a Remote-peer.
<Quidway>system-view
[Quidway] mpls ldp remote-peer 22
Chapter 1 MPLS Basic Configuration Commands
Huawei Technologies Proprietary
1-24