Subaru Legacy 2003 Service Manual page 3080

DIAGNOSTICS CHART WITH DIAGNOSIS CONNECTOR
Step
30 CHECK HARNESS/CONNECTOR BETWEEN
VDCCM AND VDCH/U.
Measure resistance between VDCCM connec-
tor and VDCH/U connector.
Connector & terminal
(F87) No. 3 — (VDC2) No. 2:
(F87) No. 51 — (VDC2) No. 2:
(F87) No. 50 — (VDC2) No. 2:
(F87) No. 4 — (VDC2) No. 2:
(F87) No. 2 — (VDC2) No. 2:
(F87) No. 29 — (VDC2) No. 2:
Is the measured value within the specified
range?
31 CHECK POOR CONTACT IN CONNECTORS.
Is there poor contact in connector between
VDCCM and VDCH/U?
32 CHECK VDCCM.
1) Connect all connectors.
2) Erase the memory.
3) Perform inspection mode.
4) Read out the diagnostic trouble code.
Is the same diagnostic trouble code as in
the current diagnosis still being output?
33 CHECK ANY OTHER DIAGNOSTIC TROU-
BLE CODES APPEARANCE.
Are other diagnostic trouble codes being out-
put?
Value
4.0 — 6.0 Ω
There is poor contact.
Same DTC indicated.
Other DTC indicated.
VDC-107
VDC (DIAGNOSTICS)
Yes
Go to step 31. Repair harness/
connector
between VDCH/U
and VDCCM.
Repair connector. Go to step 32.
Replace VDCCM. Go to step 33.
<Ref. to VDC-8,
VDC Control Mod-
ule (VDCCM).>
Proceed with the A temporary poor
diagnosis corre- contact.
sponding to the
diagnostic trouble
code.
No