Software Installation
Operation Software
10-40
Chapter 10 Setup Operations
This section describes the procedure for installing the BZDM-7020
operation software.
When a new version of the software is issued follow the following
instructions to install the new version.
The BZDM-7020 operatopn software is supplied on two floppy
disks, labeled "SYSTEM DISK 1" for the control panel, and
"SYSTEM DISK 2" for the processor.
Note
The BZDM-7020 is accompanied by software installation labels.
These are required when the DME-7000 is serviced, so you should
affix them as follows.
• Attach the label for "SYSTEM DISK 1" to the rear panel of the
control panel.
• Attach the label for "SYSTEM DISK 2" to the rear panel of the
processor.