Sony BZDM-7020 User Manual page 342

Input Signal Settings – 712
10-24
Chapter 10 Setup Operations
2
Press F4 (SIGNAL TYPE), to select "Digital" or "Analog".
3
Press F5 (XPT NUMBER), then enter the DME cross-point
number assigned to the input button number selected in step 1,
using the numeric keypad, and in the following ranges.
Digital video switcher: no specification required
BKDM-5080: 1 to 32
BVS-V1201/DVS-V1201: 1 to 23
For details of the assignment of DME cross-point numbers on
BVS-V1201/DVS-V1201 units, see "Assignment of DME
cross-point numbers on BVS-V1201/DVS-V1201 units" (page
10-26).
4
Press F6 (SIGNAL FORMAT), to select the signal format.
Pressing F6 cycles through a range of possibilities, as follows.
• Composite systems: 0 IRE n 7.5 IRE
• Component systems, 525 lines: SMPTE n B-CAM 0 n
B-CAM 7.5
• Component systems, 625 lines: EBU (display only)
Note
In a component system, this operation is only valid if you
selected "Analog" in step 2 above.
5
Depending on the input signal phase difference, press F7
(TBC CENTER) to change the center position of the TBC
window.
Pressing F7 cycles through the values 0H n 0.5H n 1.0H
n 1.5H.
The automatic correction range (the TBC window) is ±0.3H
centered on the center position selected.
When using a Sony digital video switcher (DVS-2000-series,
DVS-6000/6000C, DVS-7000, DVS-8000/8000C, etc.) or a
BKDM-5080 as source selector, normally select 1H.
If using a BVS-V1201/DVS-V1201, select 0H.