Sony BZDM-7020 User Manual page 315

REV: Reverse the direction of the effect. (Same as the REVS
button)
STOP NEXT KF: Run the effect up to the next key frame.
0 : Rewind. (Same as the REW button)
: Move back one key frame. (Same as the PREV KF button)
: Move back one frame.
p
: Stop the effect.
( : Run the effect. (Same as the RUN button)
: Move forward one frame.
: Move forward one key frame. (Same as the NEXT KF
button)
) : Move to the last key frame.
Changing the section of the timeline displayed – F1
(EXPAND)
Use the following procedure to change the start point of the section
of the timeline displayed or the scale.
1
Press F1 (EXPAND).
2
To change the start point, adjust the left knob ("Start").
3
To change the length of the section displayed (i.e. the scale),
adjust the right knob ("Width").
Setting a pause position – F3 (PAUSE)
This determines the position at which the effect stops after
execution.
Note
The pause setting is only effective when you execute the effect
using the RUN button on the control panel or by a GPI trigger.
When executing an effect under the control of a DVS-6000/6000C/
7000 switcher system using the key frame link function, or from
an editor, the pause setting is ignored.
1
Select the channel or channels to which the setting is to apply.
2
Stop the effect at the desired pause position.
3
Press F3 (PAUSE).
This sets the pause.
Chapter 9 Status Displays
9-9