Moving the Image
Moving in the Source Coordinate Frame
Procedure
Moving along the x-axis
SRCE button
LOC XYZ button
(or LOC SIZE button)
3-8
Chapter 3 Three-Dimensional Transformation
This section describes how to move the image in either the source
or target coordinate frame.
To move the image in the source coordinate frame, use the
following procedure in the transformation operation section.
1
In the function allocation section, press the SRCE button,
turning it on.
2
In the transformation mode selection section, press the LOC
XYZ button, turning it on.
If you wish to move the image in the x- and y-directions only,
pressing the LOC SIZE button has the same effect.
3
Move the trackball to move the image in the x- and y-
directions.
Turn the Z-ring to move the image in the z-direction.
RUN
CURSR
CTRL
SRCE
TRGT
ASP
LOC
LOC
SKEW
SIZE
XYZ
PERS
AXIS
ORTHG
ROT
LOC
X
Y
Z
VELO
CTR
HOLD
SEL/FINE
Control panel operation
Video change