Setting Up The Gpi Inputs - 704 - Sony BZDM-7020 User Manual

Setting Up the GPI Inputs – 704
Use this menu to set up the processor to accept and be controlled
by GPI outputs from a BVE-2000 or other editing control unit.
To make these settings effective, set F5 (GPI IF) to "Enable" in the
OPERATION menu (see page 10-7).
With the first set of soft key indications shown in the SETUP &
DIAG menu, press F4 (GPI IN) to display the GPI IN menu.
704 GPI IN
GPI No. Trigger type
1 Off
2 Off
3 Off
4 Off
TRIGGER ACTION
TYPE PREVIUS
The following is a typical operation carried out in this menu.
Setting up the GPI inputs
This selects the trigger type and action to be carried out in
response to each of the GPI input ports on the DME-7000.
Use the following procedure.
1
Use the control panel ˘ and ≥ buttons to select the number of
the GPI port for which you wish to make the setting.
2
Press F2 (TRIGGER TYPE) to select the trigger type.
Pressing F2 cycles through the following possibilities.
Rise edge: Positive pulse. A rising edge acts as the trigger.
( )
Fall edge: Negative pulse. A falling edge acts as the
trigger. ( )
Flip flop: Flip-flop. Each switch in polarity of the signal
acts as the trigger. (
Off: No operation.
Action
NOP
NOP
NOP
NOP
ACTION
NEXT
GPI IN menu
)
Chapter 10 Setup Operations
E G 1 2 3 4 R
ACTION LIST
NOP Rewind jitter
+1 Frame
Recall EFF #
Run –1 Frame
Stop +1 Field
–1 Field
Rewind
4:3
Freeze
Foward jitter 16:9
EFFECT
NUMBER
(Continued)
10-13