Starting Up And Powering Off - Sony BZDM-7020 User Manual

Starting Up and Powering Off

Starting up
Powering off
Powering on the processor and menu monitor starts the system,
and the initial screen (see page 4-9) appears on the menu monitor.
The system is now ready for control panel and menu operations.
Start-up state
It is possible to save function on/off settings and parameter values
in nonvolatile memory, and arrange to recall these settings
automatically when the system is started.
If no such setting is made, the system starts up with the factory
default settings.
For details see "OPERATION menu" on page 10-7.
You can power off the system regardless of the current display on
the menu monitor.
Note
Do not power the unit off during any of the following operations.
• While a floppy disk is being accessed (see "Floppy Disk
Operations – 77" on page 8-19)
This may cause files on the floppy disk, or backup copies of data
in the processor (contents of effect registers or snapshot registers)
to be corrupted.
• During installation of the software (see "Installing the Software
in the Processor – 724" on page 10-42)
• While writing setup data (see "Settings Related to Operation –
702" on page 10-7)
The data being written may be corrupted. If you power the unit
off inadvertently, restart the system with the factory default
settings, then make the required settings or restore the settings by
loading again from the floppy disk.
1-5
Chapter 1 Overview