Sony BZDM-7020 User Manual page 239

Setting the output source and output phase
Use the following procedure.
1
Press F5 (OUTPUT SOURCE) to select the output source
according to the desired EXT/C output.
Desired EXT/C output
EXT/C input (output 1 frame delayed)
Combined signal (KEY/Z signal) of KEY
and Z for the depth key used when a
DVS-2000C is connected
a) While using the EXT/C input internally to the DME-7000, the EXT/C
output becomes a gray level signal.
b) The output from the KEY/Z connector of the COMBINER OUTPUTS
(for connection to a downstream DME-7000) also becomes a KEY/Z
signal.
2
Turn the left knob ("Phas") to adjust the output phase.
(–25.03 to +25.03 µs)
Notes on setting the output source to KEY/Z
• When combining the output image from the DME-7000 using
depth keying on a DVS-2000C, if you set the key type to
"External" or "Luminance" and set the "RECUR" (recursive)
item to "ON", the edges of the combined image will be jagged.
• Even if you set the DME-7000 "BKGD" (background) item to
"ON", the same KEY/Z signal is output as in the case of "OFF".
Output source selection
a) EXT VIDEO
b)
KEY/Z
Chapter 6 Input/Output Signal Operations
6-15