Signal Processing Settings - 716 - Sony BZDM-7020 User Manual

Signal Processing Settings – 716
10-32
Chapter 10 Setup Operations
This menu selects settings for signal processing within the DME-
7000.
With the second set of soft key indications shown in the SETUP &
DIAG menu, press F6 (PROCESS CTRL 1) to display the
PROCESS CONTROL 1 menu.
716 PROCESS CONTROL 1
•
Filter Mode Mode 1
•
Filter Type
Flat
•
Limiter Video
Matte Lum Max Lum 80.00
White/Dark Clip Wht 80.00
•
External Key Process
•
Key Filter Off
•
Analog Ext Key With sync
FILTER FILTER VIDEO
MODE TYPE LIMITER
PROCESS CONTROL 1 menu
The following are some of the operations carried out in this menu.
Selecting the filter type – F1 (FILTER MODE)
There are two sorts of filter processing which can be applied to the
video signal: press F1 (FILTER MODE) to toggle between them.
Mode 1: the filter corrections are such as to make the picture
clearly visible even when compressed.
Mode 2: the filter corrections are such as to reduce aliasing
problems when the picture is enlarged or compressed.
Selecting the filter type – F2 (FILTER TYPE)
Flat: Applies a uniform filter.
Depth: Controls the strength of the filter separately for each pixel
on the basis of the depth information.
Setting the video signal color limiter – F3(VIDEO
LIMITER)
Press F3(VIDEO LIMITER), to switch on the video signal color
limiter, which prevents illegal colors from being generated.
Setting the matte signal color limiter – F4 (MAT COL
LIMITER)
Press F4 (MAT COL LIMITER), to switch on the matte signal
color limiter, which prevents illegal colors from being generated.
•
Mode 2
•
Depth
• Matte
Dark –20.00
•
Through
• Low pass • Trap
• Without sync
MAT COL EXTERNAL
LIMITER KEY
E G 1 2 3 4 R
KEY ANALOG
FILTER EXT KEY