Sony BZDM-7020 User Manual page 229

3
Press F3 (FORMAT), to select the input signal format.
On component systems, this setting and associated indications
are only effective if you selected "Analog" in step 1.
Pressing F3 cycles through the following possibilities.
• On composite systems: 0 IRE n 7.5 IRE
• On component 525-line systems: SMPTE n B-CAM0 n
B-CAM7.5
• On component 625-line systems: "EBU" is displayed.
4
Depending on the input signal phase difference, press F4
(TBC CENTER) to change the center position of the time base
corrector window.
Pressing F4 cycles through the values 0H n 0.5H n 1H n
1.5H.
The automatic correction range (the TBC window) is ±0.3H
centered on the center position selected.
When the input signal is from the AUX BUS of a Sony DVS-
series digital video switcher, normally select 1H.
5
Select "Phase", and turn the left knob ("Phas") to adjust the
input signal phase. (–8 to +8)
When using analog signals in a composite system, turn the
center knob ("SC") to adjust the subcarrier phase. (–100 to
+100)
6
To use a two-sided video image, that is with different front
and back video signals, press F6 (SEPARATE SIDE), turning
it on.
When "Separate Side" is on, you can use the BACK VIDEO
menu (see page 6-8) to select the back video signal.
Chapter 6 Input/Output Signal Operations
6-5