Sony BZDM-7020 User Manual page 361

5
To confirm the installation, press F5 (OK); to abort the
installation press F6 (CANCEL).
The installation begins. The process takes approximately ten
minutes, during which no other operations are possible.
If the installation completes normally, a message "Finished"
appears.
Setting up the state to be recalled at power on after
installing software
After installing a new software version in the processor, the
previous setup data is preserved. Use the following procedure to
change the settings to be recalled at power on after upgrading.
1
In the OPERATION menu (menu page 702), press F2
(POWER ON), to select "User define."
For details of the OPERATION menu, see page 10-7.
2
Momentarily power off the processor and power it on again, to
restart the system.
3
Make all the setting changes and additional settings to the
required initial state.
4
In the OPERATION menu, press F7 (PWR ON DEFINE).
Chapter 10 Setup Operations
10-43