Settings Related to Operation – 702
This menu controls various settings related to operation from the
control panel.
With the first set of soft key indications shown in the SETUP &
DIAG menu, press F2 (OPERATION) to display the
OPERATION menu.
702 OPERATION
•
Clear Work Buff
Factory set
•
Power On
Factory set
•
Top Menu Button
Top menu
•
Disable
Editor Interface
•
GPI Interface
Disable
•
Disable
Switcher Interface
CLEAR
POWER
TOP MENU
WRK BUFF
ON
BUTTON
The following are some of the operations carried out in this menu.
Selecting the initializing mode for the working key frame
buffer – F1 (CLEAR WRK BUFF)
Pressing the CLEAR WORK BUFF button in the key frame
operation section initializes the working key frame buffer. There
are two options for the state to which the working key frame buffer
is cleared, selected by pressing F1 (CLEAR WRK BUFF) as
follows.
Factory set: Clear to the factory default settings.
User define: Clear to the settings determined using F8 (CLR
WRK DEFINE).
Selecting the power on mode – F2 (POWER ON)
There are two options for the initial state of the display when the
system is powered on, selected by pressing F2 (POWER ON) as
follows.
Factory set: Initialize to the factory default settings.
User define: Initialize to the settings determined using F7 (PWR
ON DEFINE).
•
User define
•
User define
•
Last menu
•
•
DME protocol
VTR protocol
•
Enable
•
Enable
EDITOR
GPI
SW'ER
IF
IF
IF
OPERATION menu
Chapter 10 Setup Operations
E
G 1 2 3 4 R
PWR ON
CLR WRK
DEFINE
DEFINE
10-7