Sony BZDM-7020 User Manual page 290

Disk Utilities
Loading a file – LOAD
8-20
Chapter 8 Effect Utilities
2
Press F2 (FUNCTION), to display "SAVE" in green.
The indicator to the left of the "SAVE" item lights, and a
message appears as follows. (The soft key indication for F8
changes to "OK".)
Select registers and press [Cancel]/[OK]
3
Use F3 (˘) or F4 (≥) to display the required register number
in green, and then press F5 (SELECT). Alternatively, click on
the register number displayed on the screen, using the mouse.
To specify all registers, press F6 (ALL).
A blue bar appears attached to the register number. Repeat
step 3 as necessary, if you wish to save more than one file.
4
To make the destination file numbers on the disk different
from the register numbers, use the numeric keypad to enter the
file number for the first register in the range.
To save with the file numbers the same as the register
numbers, no entry is required.
5
To confirm the save press F8 (OK). To abort the save, press
F7 (CANCEL).
This saves the register or registers with the same file number
or numbers as the register number or numbers.
Use the following procedure to load a register in the processor
from a floppy disk.
1
Insert the floppy disk containing the file to be loaded in the
floppy disk drive.
2
Press F8 (READ DISK).
Note
If you change floppy disks, then until you press F8 (READ
DISK) the file display is not updated.