Sony BZDM-7020 User Manual page 275

Copying the contents of specified registers – F2 (COPY)
Use the following procedure.
1
Press F2 (COPY).
The legend "COPY" appears in the numeric keypad area.
2
Enter the number of the first source register whose contents
are to be copied using the numeric keypad, and press the
ENTER button.
The entered register number appears in the numeric keypad
area followed by a dash. (e.g. "COPY 12 –")
3
Enter the number of the last source register whose contents are
to be copied using the numeric keypad, and press the ENTER
button. Alternatively, click on the register number displayed
on the screen, using the mouse.
The entered register is appended to the message in the numeric
keypad area, and then further "to" is appended (e.g. "COPY
12 – 24 to").
To copy only the register whose number was
entered in step 2
In step 3, without entering a register number, simply press the
ENTER button.
The legend "to" is appended in the numeric keypad area.
4
Enter the number of the first destination register to which the
contents are to be copied using the numeric keypad, and press
the ENTER button. Alternatively, click on the register
number displayed on the screen, using the mouse.
The contents of the range of registers specified as source are
copied to the range of registers specified here.
Notes
• The previous contents of the destination registers are
destroyed by the copy operation.
• If a register is write-protected, a copy operation with this
register as the destination register is not carried out.
Chapter 8 Effect Utilities
8-5