Transformation Operation Section - Sony BZDM-7020 User Manual

Transformation Operation Section

The transformation operation section is
used for three-dimensional image
1 Function allocation section
Press any one of these buttons, turning it
on, to allocate the trackball 2 and Z-ring
3 as follows.
RUN CTRL (control) button:
Allocates the trackball and Z-ring to
effect execution.
SRCE (source) button: Allocates the
trackball and Z-ring to transformation
operation in the source coordinate
frame, that is, the coordinates based
on the video image itself.
TRGT (target) button: Allocates the
trackball and Z-ring to transformation
operation in the target coordinate
frame, that is, the coordinates based
on the output video space on the main
monitor.
.................................................................................................................................................................................................................................................
1) The rate of movement of image or cursor can be
varied in the TRACK BALL menu (page 10-10).
RUN
CURSR
CTRL
SRCE TRGT
ASP
LOC LOC
SKEW
SIZE XYZ
PERS
AXIS
ORTHG ROT
LOC
X Y Z
VELO
CTR
HOLD
SEL/FINE

Transformation Operation Section

1)
1)
manipulation and cursor movement on
menu screens.
1 Function allocation section
2 Trackball
3 Z-ring
4 SEL/FINE button
5 Transformation mode selection section
CURSR (cursor) button: Allocates the
trackball to cursor movement on the
menu screens.
This also allocates the Z-ring to
adjust the parameter at the cursor
position.
2 Trackball
Depending on the state of the buttons in
the function allocation section 1,
trackball operation can be allocated to
effect execution, x- and y-axis movement
in transformation operations, or cursor
movement on the menu screens.
Chapter 2 Location and Function of Parts
1)
2-3