Sony BZDM-7020 User Manual page 100

Background and Edge Effects
5-16
Chapter 5 Special Effects Operations
Adjusting the border width and density
Adjust the parameters for the items shown below.
The border is based on the setting in the CROP menu (see page 5-
18); you can apply the border in either the positive direction
(defined as on the inside of the frame) or in the negative direction
(on the outside).
Item Setting
"Width All" a) Adjust the width
of two or four
edges together.
"Separate Adjust the width
Width" of all four edges
separately.
"Density" Adjust the density
of the border.
a) The parameter values for this item are always shown as "***", but the
setting is reflected in the individual parameter values under "Separate
width". It is also possible to input a value from the numeric keypad.
Left
BORDER settings
Knob adjustments of parameters
Left ("H"): Adjust width of left and right
edge border.
Center ("V"): Adjust width of upper
and lower edge border.
Right ("All"): Adjust width of border on
all four edges.
Left ("Left"): Adjust width of left edge
border (–0.20 to +8).
Center ("Right"): Adjust width of right
edge border (–0.20 to +8).
Left ("Top"): Adjust width of upper
edge border (–0.20 to +8).
Center ("Bttm"): Adjust width of lower
edge border (–0.20 to +8).
Left ("Dens"): Density (0 to 100%).
Top
Bttm Right