Setting The Security Status - Sony MSU-700A Operation Manual

To cancel the security code
If the operator forgets the security code, or if an
adjustment in Engineer mode becomes necessary in an
emergency when the unauthorized operator is absent,
the security code can be canceled by the following
procedure:
1
Turn on the power to the MSU-700A while
holding PARA, PANEL ACTIVE and camera
select button 1 pressed.
PARA button
WAVEFORM MONITOR
PARA
MULTI
TALLY
PANEL
ACTIVE
1 2 3
EXPAND
Camera select button 1
PANEL ACTIVE button
The numeric keys appear on the display.
2
Press [0][3][5][9] of the numeric keys to enter
"0359" in the field for the security code, then press
[OK].
The Engineer Protection display now appears.
Engineer Protection
Protection
Code
Enable
Code
Delete
3
To delete the security code, press [Code Delete].
To temporarily disable the security code, press
[Code Enable] to change it from inverse video to
unhighlighted display. (Once you press it again to
return it to inverse video, the security code is
enabled.)
4
As the message "Code Delete OK?" is displayed if
you press [Code Delete] in step 3, press [OK] to
return to the Engineer Protection display.
5
Press [Exit].
CC
4 5 6 7 8 9 10 11
Exit

Setting the Security Status

You can limit the control functions of the MSU-700A
when required.
This status setting is enabled in Engineer mode.
Operation
Proceed as follows:
Configuration Menu
MODE
Configuration Menu
CCU
Camera
MULTI
CNU MSU
1
CARD
CONFIG
MAINTENANCE
FILE
PAINT
1
Press to light the CONFIG button.
The Configuration Menu appears on the display.
2
Press [MSU].
The MSU Configuration Menu appears.
MSU Configuration
MSU MSU SW
Adjusting Set
Date /
Time
2
Exit
Security
(Continued)
23 (E)