Setting The Switches - Sony IFB-40 Operating Instructions Manual

Mounting the IFB-40
Note
Mounting or removal of signal interface boards must be performed by
qualified personnel only.
This section is for qualified personnel only.
1
1 Loosen the screws completely and remove the panel.
2 Push in the IFB-40 along the rail.
3 Tighten the screws.
When disconnecting the IFB-40, loosen the screws completely and
pull it out.

Setting the Switches

Setting the switcher/projector switch
Set to SW when mounting on the signal interface switcher PC-3000.
Set to PJ when mounting on a projector.
2
Switcher/projector
PJ SW
switch
IFB-40.3-858-498-03 (1)
3
11