Operation - Sony MG10-P1 Manual

6. Operation

Operations are performed by commands which use RS-232C com-
munication and by the input of signals from the I/O connector.
(If the I/F module has been connected, operations from the I/F
module can also be performed. For further details, refer to the
instruction manual of the I/F module.)
Check the reference point setting while referring to section "4-2-3.
Reference point" function as well.
n
All contents other than those set by the setup commands are deleted
when the power is turned off.
Type of operation
Measuring mode changes
Preset value recall
Reset
Start
Preset value setting
Comparator value setting
Comparator set number selection
Peak value data update stop (Pause)
Current value data output latch
Reference point load
Reference point offset value read
Software version read
Alarm output
26
(E)
RS-232C I/O connector
O
O
O O (All channels at once)
O O (All channels at once)
O
O
O
O O (All channels at once)
O O (All channels at once)
O
O
O
O O (Overall alarm)
MG10-P1 / MG10-P2