Offset-List - Dell Z9500 Reference Manual

Hide thumbs Also See for Z9500:

Table of Contents

offset-list

Specify a number to add to the incoming or outgoing route metrics learned using RIP.

offset-list prefix-list-name {in | out} offset [interface]

To delete an offset list, use the no offset-list prefix-list-name {in |

out} offset [interface] command.

prefix-list-

Not configured.

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Enter the name of an established Prefix list to determine

which incoming routes are modified.

Enter a number from zero (0) to 16 to be applied to the

incoming route metric matching the access list specified. If

you set an offset value to zero (0), no action is taken.

(OPTIONAL) Enter the following keywords and slot/port or

number information:

For a Port Channel interface, enter the keywords port-

channel then a number. The range is from 1 to 512.

For a 10-Gigabit Ethernet interface, enter the keyword

TenGigabitEthernet then the slot/port information.

For a 40-Gigabit Ethernet interface, enter the keyword

fortyGigE then the slot/port information.

For a VLAN, enter the keyword vlan then a number from

Introduced on the S6000-ON.

Introduced on the S6000.

Introduced on the S4820T.

Introduced on the Z9000.

Added support for 4-port 40G line cards on ExaScale.

Introduced on the S4810.

Introduced on the S-Series.

Routing Information Protocol (RIP)