CareFusion Alaris 8015 User Manual page 8

Product/Feature
Guardrails™ hard limit
Guardrails™ IV fluid
Guardrails™ limit
Guardrails™ PCA pause
protocol
Guardrails™ soft limit
SmartSite™ needle-free valve
CareFusion recommends the use of CareFusion manufactured
parts in the operation and maintenance of your CareFusion
equipment. Customer's use of repair or service parts, add-ons,
or disposables that are not approved by CareFusion is at
Customer's own risk and may void the product warranty
provided by CareFusion. Any 510(k) clearance from the Food
and Drug Administration (FDA) or regulatory approval secured
by CareFusion to market Alaris pumps was based on use of
only CareFusion manufactured parts and equipment. If non-
CareFusion parts, add-ons or disposables are used for the
maintenance, repair or operation of your CareFusion
equipment, those parts were not validated by CareFusion for
safety and efficacy with our Alaris products, nor were they
included in the review and approval/clearance of the products.
Instruments are tested and calibrated before they are
packaged for shipment. To ensure proper operation after
shipment, it is recommended that an incoming inspection be
performed before placing the instrument in use.
Prior to placing the Alaris System in use:
1. Perform check-in procedure using System Maintenance
software.
2. Whether or not Profiles feature has been enabled
(see PC unit section, "System Options," "System

Configurations").
NOTE:
To enable the Profiles feature, a hospital-defined best-practice

Data Set must be uploaded to the PC unit.
viii
Introduction (Continued)
Defined Term
Hard Limit
IV Fluid
Limit
PCA Pause Protocol
Soft Limit
Needle-Free Valve
Approved Parts Recommendation
Installation
Alaris System User Manual – with v9.33 Model 8015