Programming With Interoperability-Initial Primary Infusion - CareFusion Alaris 8015 User Manual

Programming with Interoperability—Initial Primary Infusion
1. Perform the following steps on the PC unit (see the PC unit
section of "General Setup and Operation" and "Start-Up"
beginning on page 1-3):
a. Power on system. (Scanning the module will not power
on the device.)
b. Select or
Yes
c. Confirm current Profile or select a new Profile. This
places the module in an idle state (not infusing or in the
process of being programmed as illustrated Channels
A and B).
2. Prepare the Administration Set for the Pump module, see
Prepare Administration Set (Pump Module) on page 2-3.
3. Prime the Administration Set, see Prepare Syringe and
Administration Set (Syringe Module) on page 2-7.
Programming with Interoperability and Guardrails Suite MX
2-62
to
No New Patient?
Pump and Syringe Modules Section
Alaris System User Manual – with v9.33 Model 8015