Service Information - CareFusion Alaris 8015 User Manual

1. Use a clean soft cloth or lens tissue dampened with warm
water or a mild nonabrasive detergent-water solution to
clean all exposed surfaces.
2. Use a clean soft cloth or lens tissue dampened with water
to rinse off cleaning solution.
3. Ensure that window is dry before returning to use.
If the instrument shows evidence of damage in transit, notify
the carrier's agent immediately. Do not return damaged
equipment to the factory before the carrier's agent has
authorized repairs.
If the instrument fails to respond as described in this document
and the cause cannot be determined, do not use the
instrument. Contact qualified CareFusion service personnel.
If it is necessary to return the instrument for service, obtain
a return authorization number prior to shipment. Carefully
package the instrument (preferably in the original packaging),
refer to the return authorization information, and return it to
the appropriate service or distribution center. CareFusion
does not assume any responsibility for loss of, or damage to,
returned instruments while in transit.
.
Technical support, service information, applications, and
manuals can be obtained by contacting a CareFusion
representative. 888-812-3229.
When submitting any request for service, include:
• model number
• a description of difficulty experienced
• instrument settings
• administration set/lot number
• solution(s) used
• message displayed at time of difficulty
Appendix Section
Alaris System User Manual – with v9.33 Model 8015

Service Information

Handheld Scanner
Technical Support
CAUTION
• Do not use abrasive wipes
or tissues on the scanner's
window.
• Do not use solvents (such
as acetone, benzene, ether,
phenol-based agents). These
can damage the scanner's finish
and window.
• Do not immerse in fluids.
WARNING
• The instrument case should
only be opened by qualified
personnel using proper
grounding techniques. Prior
to performing maintenance,
disconnect attached module
from the Alaris System and the
PC unit from AC power.
• During servicing, an instrument's
configuration settings might
be reset to the factory defaults.
Qualified hospital/facility
personnel are responsible for
checking in the instrument and
ensuring the current hospital-
approved Data Set is loaded.
A-33