Anesthesia Mode - CareFusion Alaris 8015 User Manual

When the Anesthesia Mode is enabled and then the pause
feature is used - the module remains in an indefinite pause until
restarted.
When Anesthesia Mode is enabled:
• A channel can be paused indefinitely without an alarm.
• The air-in-line associated with the Profile can be set up to
500 micro liters.
• All limits are set to Soft.
• Limit Checking mode is set to Smart.
• Key-press audio is turned off.
• Auto-Restart for Anesthesia Mode is set to 9 and is not
configurable.
• Panel Lock through Tamper Resist Mode or Authorized
User Mode is not available.
• Guardrails drug list defaults to drugs designated by Editor
Software as anesthesia only. All Guardrails drugs in a
Profile can be viewed by pressing ALL DRUGS soft key.
• Bolus Dose is automatically available for:
◦ Guardrails drugs that have Bolus Dose limits defined
◦ generic drug calculation setup
• Anesthesia Mode, alternating with other required prompts,
is displayed in prompt bar of Main Display.
• Callback audio for paused module is permanently silenced.
• Review of drug calculation setup page is omitted when
restoring a stopped drug calculation.
• Clinical Advisories are not displayed.
NOTE:
If an infusion is paused in regular mode and then the anesthesia
mode is enabled - the device will alarm at the 2 minute warning.
Enable
1. Press
OPTIONS
General Setup and Operation
1-18
System Options (Continued)

Anesthesia Mode

key.
WARNING
When the Alaris System is set up for
use in Anesthesia Mode, it is
important to select the Profile that
corresponds with the care area the
patient will be taken to when the
Anesthesia Mode is discontinued.
This ensures that the Alaris System
will be in the correct Profile following
the use of the Anesthesia Mode.
Alaris System User Manual – with v9.33 Model 8015
System Options 1 of 3
Display Contrast
Patient ID
Clinician ID
Power Down All Channels
Anesthesia Mode
>Select an Option or
EXIT
PAGE
EXIT
DOWN
PC Unit Section