CareFusion Alaris 8015 User Manual page 133

Programming with Interoperability—Initial Primary Infusion (Continued)
Continuous Infusion
The following workflow assumes that the Patient's ID band,
medication/fluid barcode label, and the module barcode labels
have been scanned, see Programming with Interoperability—
Initial Primary Infusion on page 2-62.
1. Review and verify that all parameters pre-populated on the
Alaris System are correct prior to starting the infusion.
The drug amount, diluent volume, and patient weight (if
continuous infusion is weight based) are pre-populated
from the automated programming request.
2. Press to confirm.
NEXT
NOTE:
Syringe module:
• ALL Mode can still be enabled with interoperability.
However, the VTBI pre-populates with the volume to be
infused from the automated programming request.
• If the VTBI in the automated programming request is
greater than the actual volume in the syringe (for example,
priming the IV disposable with the syringe would decrease
the available volume in the syringe), the Alaris System will
display the VTBI field as blank and the message in the
prompt line on the Alaris PC unit would state: Value x
Exceeds MAX VTBI y. The clinician can either manually
program a value for the VTBI or use the ALL button if
appropriate (and if the ALL Mode is enabled in the data
set).
3. Review and verify that all parameters pre-populated on the
Alaris System are correct prior to starting the infusion.
The rate, VTBI and dose are pre-populated from the
automated programming request.
4. Press the
START
Pump and Syringe Modules Section
Alaris System User Manual – with v9.33 Model 8015
soft key.
Programming with Interoperability and Guardrails Suite MX
A
Alteplase
Stroke
DRUG
100
mg
AMOUNT
DILUENT 100
mL
VOLUME
PATIENT
70 kg
WEIGHT
TIME
hour
UNITS
DOSING mg/kg/h
UNITS
[Conc]: 1 mg/mL
>Press NEXT to Confirm
DRUG
NEXT
LIBRARY
A A A Alteplase
Stroke
CONTINUOUS INFUSION
56.7
RATE
mL/h
100
VTBI
mL
0.81
DOSE
mg/kg/h
[Conc]: 1 mg/mL
>Press START
PAUSE SETUP BOLUS START
2-67