Authorized User Mode - CareFusion Alaris 8015 User Manual

Authorized User Mode is a feature that:
• Combines PC unit tamper resist feature with Auto-ID
application.
• Is designed to ensure that only clinicians with a barcode
on their ID badge can program Alaris System.
• Is available only if it is enabled in selected Profile and there
is an Alaris Auto-ID module attached.
When this feature is enabled, the PC unit automatically enables
the tamper resist mode upon power on and 5 minutes after
programming is completed. If the system is configured to do so,
the Authorized User Mode can be disabled without scanning a
clinician's ID; press and hold the Tamper Resist Switch (on
back of PC unit) for 3 - 4 seconds.
To unlock the keypad, the user must scan their ID badge or
use the menu to manually input their ID number.
OPTIONS
When a questionable barcode is scanned at the main screen
and the keypad is unlocked, a prompt to confirm the type of
barcode scanned appears. This occurs whether the Authorized
User Mode is enabled or disabled.
To use Alaris System with Authorized User Mode enabled:
1. Power on system and associate patient ID (see "Patient
Identification" procedure).
Upon successful entry of patient ID, PC unit automatically
enables tamper resist feature.
2. To disable tamper resist, press
Auto-ID module or the
and scan clinician ID badge.
In a very low battery condition, with less than 5 minutes
of battery time remaining, scanner is disabled. In this
situation, disable tamper resist by pressing Tamper Resist
Switch on back of PC unit for approximately 2 seconds.
Programming
6-6

Authorized User Mode*

/
SCAN CANCEL
trigger on handheld scanner
SCAN
key on the
Alaris System User Manual – with v9.33 Model 8015
Auto-ID Module Section