Getting Started; Introduction - CareFusion Alaris 8015 User Manual

This section only applies to legacy SpO
v9.33 software.
This section of the User Manual provides SpO
(Models 8210 and 8220) instructions and information. It is used
in conjunction with:
• Nellcor ™ and Masimo SET
• PC unit section of this User Manual
• Nellcor™ Monitor Sensor Compatibility Card - Alaris™ SpO2
Module Model 8210
• Masimo Monitor Sensor Compatibility Card - Alaris
™
Module Model 8220
• SpO module Technical Service Manual
2
• System Maintenance software (and its instructions) for
Alaris System check-in, maintenance, and wireless configuration
The SpO modules are indicated for continuous, noninvasive
2
monitoring of functional oxygen saturation of arterial
hemoglobin (SpO ) and pulse rate measured by an SpO
2
sensor. The SpO modules and accessories are indicated for
2
use with adult, pediatric, and neonatal patients, and for patients
who are well or poorly perfused in hospitals and hospital-
type facilities. The Model 8220 SpO
for use during motion and no motion conditions. Only one
SpO module can be connected to the Alaris System.
2
Please consult the facility's best practices guidelines on the
preferred alarm settings for the monitoring of patients that are
not continuously attended by a clinician.
The majority of user interface programming is identical for both
SpO modules. If a procedure/information applies to a specific
2
module, the following identifiers indicate the applicable model.
Model 8210:
(8210)
Model 8220:
(8220)
SpO Module Section
2
Alaris System User Manual – with v9.33 Model 8015

Introduction

users upgraded with
2
module
2
™ cable and sensor instructions
module is also indicated
2
WARNING
Read all instructions for the
SpO
2
using the Alaris System.
SpO2
™
2

Getting Started

module and PC unit, before
Getting Started
4-1