Monitoring Mode - CareFusion Alaris 8015 User Manual

Display references throughout this procedure are for illustration
purposes only.
See "General Information," "Features and Displays" and
PC unit section of this User Manual for information about:
• Displays
• Operating Features, Controls, Indicators
1. Perform following steps (see PC unit section of this User
Manual, "General Setup and Operation," "Start-Up"):
a. Power on system.
b. Choose or
Yes
c. Confirm current Profile or select a new Profile.
d. Enter patient identifier, if required.
2. Connect Microstream Disposable (see "Getting Started").
3. Press
CHANNEL SELECT
SENSOR WARMING
Channel Message display until EtCO
readings stabilize (up to 60 seconds).
4. Alarm limits:
• To change settings, see "Set Alarm Limits" procedure.
EtCO Module Section
2
Alaris System User Manual – with v9.33 Model 8015

Monitoring Mode

to .
No New Patient?
key.
and then
SEARCHING
and respiratory rate
2
appear in
Programming
EtCO (mm Hg)
2
RR (breaths/min)
CHANNEL
SELECT
MONITOR
CHANNEL
OFF
Programming
5-5