CareFusion Alaris 8015 User Manual page 122

Manual Programming—Secondary Infusion (Pump Module) (Continued)
8. Open clamp on secondary administration set.
9. Verify correct parameters and press
• If the programmed duration is outside the Soft Limit for
that care area, an audio alert sounds and a visual
prompt appears before programming can continue. If
Yes soft key is pressed, programming continues; if No
soft key is pressed, infusion needs to be
reprogrammed.
• If the programmed duration is outside Hard Limit for
that care area, an audio alert sounds and a visual
prompt appears before programming can continue.
Infusion needs to be reprogrammed.
• If a Soft Limit is overridden, G icon is displayed. When
G soft key is pressed, all applicable out-of-range limits
are listed.
10. Verify drops are flowing from the secondary container drip
chamber.
NOTES:
The facility can choose to pre-populate standard drug

concentrations, or leave a custom concentration (_ _ / _ _ mL)
and allow the clinician to enter the desired concentration.
Patient weight or BSA is not editable during a Secondary

Infusion.
Once a patient weight or BSA is entered and the infusion

started, the patient weight or BSA is automatically entered for
any additional weight-based or BSA calculation. Prior to the
start of infusion, the patient weight or BSA key remains an
editable field so that patient weight or BSA can be adjusted for
any module. Changing the patient weight or BSA on one
module will not affect the patient weight or BSA on any other
module.
Manual Programming with Guardrails Suite MX
2-56
Infusion (Continued)
soft key.
START
Alaris System User Manual – with v9.33 Model 8015
WARNING
The clamp on the secondary
administration set must be opened. If
the clamp is not opened, the fluid is
delivered from the primary container.
Pump and Syringe Modules Section
FU
RATE (mL/h)
CHANNEL
SELECT
PAUSE
CHANNEL
OFF
RESTART