Ip Address Dhcp - Siemens SCALANCE XC-200 Configuration Manual

7.1.3.4

ip address dhcp

Description
With this command, the VLAN interface obtains the IP address via DHCP.
Requirement
You are in the Interface Configuration mode of VLAN.
The command prompt is as follows:
cli(config-if-vlan-$$$)#
Syntax
Call the command without parameters:
ip address dhcp
Result
The DHCP assigns the IP address to the VLAN interface.
Further notes
You delete the settings with the no ip address command.
You display this setting and other information with the show ip interface command.
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06
Network protocols
7.1 IPv4 protocol
281