Arp; The "Show" Commands; Show Ip Arp - Siemens SCALANCE XC-200 Configuration Manual

7.9

ARP

This section describes commands of the Address Resolution Protocol (ARP).
7.9.1

The "show" commands

This section describes commands with which you display various settings.
7.9.1.1

show ip arp

Description
With this command, you display the IP ARP table.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
show ip arp [{vlan<vlan-id(1-4094)>|<interface-type><interface-id>|
The parameters have the following meaning:
Parameter
vlan
vlan-id
interface-type
interface-id
ip-address
mac-address
summary
information
For information on names of addresses and interfaces, refer to the section "Addresses and
interface names (Page 36)".
If you do not select any parameter from the parameter list, the IP ARP table is displayed.
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06
<ip-address>|<mac-address>|summary|information}]
Description
Keyword for a VLAN connection
Number of the addressed VLAN
Type or speed of the interface
Module no. and port no. of the interface
Shows the IP addresses of the entries
in the ARP table
Shows the MAC addresses of the en‐
tries in the ARP table
Shows a summary of the entries in the
ARP table
Displays information on the ARP config‐
uration
Network protocols
Range of values / note
-
1 ... 4094
Enter a valid interface.
-
-
-
-
7.9 ARP
363