Show Multicast-Block Config; Commands In The Global Configuration Mode (Transparent Bridge) - Siemens SCALANCE XC-200 Configuration Manual

Layer 2 management protocols
8.6 Multicast
Result
The static multicast MAC addresses are displayed.
8.6.3.3

show multicast-block config

Description
This command shows the multicast blocking settings for ports.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
show multicast-block config [port <interface-type> <interface-id)>]
The parameters have the following meaning:
Parameter
port
interface-type
interface-id
For information on names of addresses and interfaces, refer to the section "Addresses and
interface names (Page 36)".
If no parameters are specified, the settings for all ports are displayed.
Result
The multicast blocking settings for ports are displayed.
8.6.4

Commands in the global configuration mode (Transparent Bridge)

This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can be
found in the relevant sections.
You exit the Global configuration mode with the end or exit command and are then in the
Privileged EXEC mode again.
428
Description
Keyword for a port description
Type or speed of the interface
Module no. and port no. of the interface
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Range of values / note
-
Enter a valid interface
Configuration Manual, 07/2017, C79000-G8976-C361-06