Snmp Notify - Siemens SCALANCE XC-200 Configuration Manual

The parameters have the following meaning:
Parameter
GroupName
user
UserName
security-model
Result
The details of the group are deleted.
Further notes
You change the details of an SNMP group with the snmp group command.
You display the created SNMP groups with the show snmp group command.
You display the created SNMP user with the show snmp user command.
7.5.2.12

snmp notify

Description
With this command, you configure the details of the SNMP notifications.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
snmp notify <NotifyName> tag <TagName> type {Trap|Inform}
The parameters have the following meaning:
Parameter
NotifyName
tag
TagName
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06
Description
Name of the group
Keyword for the user name
Name of the user
Specifies which security settings are
used for sending.
[{volatile|nonvolatile}]
Description
Name of the SNMP notification
Keyword for a target key
Name of the target key
Network protocols
7.5 SNMP
Range of values / note
max. 32 characters
-
max. 32 characters
● v1
● v2c
● v3
Range of values / note
max. 32 characters
-
max. 32 characters
339