Dcp Forwarding - Siemens SCALANCE XC-200 Configuration Manual

Network protocols
7.1 IPv4 protocol
Commands relating to other topics that can be called in the interface configuration mode can
be found in the relevant sections.
● If you exit the Interface configuration mode with the exit command, you return to the Global
configuration mode.
● If you exit the Interface configuration mode with the end command, you return to the
Privileged EXEC mode.
7.1.3.1

dcp forwarding

Description
With this command, you configure the forwarding behavior of the interface for DCP frames.
Note
PROFINET configuration
Since DCP is a PROFINET protocol, the configuration created here is only effective with the
VLAN associated with the TIA interface.
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
dcp forwarding {block|forward}
The parameters have the following meaning:
Parameter
block
forward
Result
The forwarding behavior of the interface for DCP frames is configured.
278
Description
DCP frames are discarded
DCP frames are forwarded
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Range of values / note
-
Default: forward
Configuration Manual, 07/2017, C79000-G8976-C361-06