Commands In The Interface Configuration Mode; Rate-Limit Output - Siemens SCALANCE XC-200 Configuration Manual

10.1.2

Commands in the interface configuration mode

This section describes commands that you can call up in the interface configuration mode.
Depending on the Interface selected, various command sets are available.
In the Global configuration mode, enter the interface command to change to this mode.
Commands relating to other topics that can be called in the interface configuration mode can
be found in the relevant sections.
● If you exit the Interface configuration mode with the exit command, you return to the Global
configuration mode.
● If you exit the Interface configuration mode with the end command, you return to the
Privileged EXEC mode.
10.1.2.1

rate-limit output

Description
With this command, you configure and enable the data rate in Kbps for limiting the outgoing
data stream of the interface.
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
rate-limit output <rate-value>
The parameters have the following meaning:
Parameter
rate-value
If you do not select any parameters from the parameter list, the default value is used.
Result
The limitation of the outgoing data stream of the interface with the data rate is enabled.
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06
Description
Value for the in data rate in Kbps
Load control
10.1 Rate control
Range of values / note
Default:
The data rate is set to 0. The out‐
going data stream is not limited.
455