Show Sntp Status; Commands In The Global Configuration Mode - Siemens SCALANCE XC-200 Configuration Manual

Syntax
Call the command without parameters:
show sntp unicast-mode status
Result
The current SNTP unicast configuration is displayed.
5.3.1.3

show sntp status

Description
This command shows the settings of the Simple Network Time Protocol.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameters:
show sntp status
Result
The settings of SNTP are displayed.
5.3.2

Commands in the global configuration mode

This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can be
found in the relevant sections.
You exit the Global configuration mode with the end or exit command and are then in the
Privileged EXEC mode again.
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06
System time
5.3 SNTP client
155