Commands In The Global Configuration Mode (Vlan Bridge); Mac-Address-Table Static Multicast - Siemens SCALANCE XC-200 Configuration Manual

Layer 2 management protocols
8.6 Multicast
For information on names of addresses and interfaces, refer to the section "Addresses and
interface names (Page 36)".
If no parameters are specified, the settings for all ports are displayed.
Result
The multicast blocking settings for ports are displayed.
8.6.2

Commands in the global configuration mode (VLAN bridge)

This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can be
found in the relevant sections.
You exit the Global configuration mode with the end or exit command and are then in the
Privileged EXEC mode again.
8.6.2.1

mac-address-table static multicast

Description
With this command, you generate a static multicast MAC address entry in the forwarding
database.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
mac-address-table static multicast <aa:aa:aa:aa:aa:aa>
424
vlan<vlan-id(1-4094)>
interface([<interface-type><0/a-b,0/c,...>]
[<interface-type><0/a-b,0/c,...>]
[port-channel<1-8>]])
[forbidden-ports([<interface-type><0/a-b,0/c,...>]
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
[<interface-type><0/ab,0/c, ...>]
[port-channel <1-8>]])
Configuration Manual, 07/2017, C79000-G8976-C361-06