No Ip Dhcp-Server Icmp-Probe; Ip Dhcp-Server Pool - Siemens SCALANCE XC-200 Configuration Manual

Network protocols
7.3 DHCP server
7.3.2.4

no ip dhcp-server icmp-probe

Description
With this command you disable the function "Probe address with ICMP echo before offer".
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameter assignment:
no ip dhcp-server icmp-probe
Result
The function is disabled.
Further notes
You enable the function with the ip dhcp-server icmp-probe command.
7.3.2.5

ip dhcp-server pool

Description
With this command, you have three options of changing to the DHCPPOOL configuration mode
and to assign an interface to the IPv4 address band.
1. If you call the command ip dhcp-server pool with the parameter pool-id (1-24),
you change to the corresponding DHCPPOOL configuration mode. The corresponding pool
ID must have already been created.
2. If you call the ip dhcp-server pool command with the parameter vlan or interface-
type/interface-id, an IPv4 address band with the next free pool ID is created and the
specified interface assigned directly to it. This is followed by a change to the DHCPPOOL
configuration mode. You then configure the other settings in the DHCPPOOL configuration
mode.
3. If you call the ip dhcp-server pool command without parameters, and IPv4 address
band with the next free pool ID is created and you change directly to the corresponding
DHCPPOOL configuration mode.
You then configure the interface and the other settings in the DHCPPOOL configuration
mode.
292
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06