Commands In The Global Configuration Mode; Ip Nat - Siemens SCALANCE XC-200 Configuration Manual

Layer 3 functions
9.1 NAT
Further notes
You configure a static address translation with the ip nat static command.
You delete a static address translation with the no ip nat static command.
You configure a dynamic address translation with the ip nat pool command.
You delete a dynamic address translation with the no ip nat pool command.
9.1.2

Commands in the global configuration mode

This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can be
found in the relevant sections.
You exit the Global configuration mode with the end or exit command and are then in the
Privileged EXEC mode again.
9.1.2.1

ip nat

Description
With this command you enable NAT/NAPT for the entire device.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
ip nat
Result
NAT/NAPT is enabled globally for the entire device. The device operates as a NAT router.
Further notes
You disable NAT/NAPT for the entire device with the no ip nat command.
You display the current configuration with the command.
436
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06