Commands In The Mstp Configuration Mode; Instance - Siemens SCALANCE XC-200 Configuration Manual

Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameters:
no spanning-tree restricted-tcn
Result
The port is released for the TCN function.
Further notes
You restrict the port for the TCN function with the spanning-tree restricted-tcn
command.
6.3.6

Commands in the MSTP configuration mode

This section describes commands that you can call up in the MSTP configuration mode.
In the Global configuration mode, enter the spanning-tree mst configuration
command to change to this mode.
● If you exit the MSTP configuration mode with the exit command, you return to the Global
configuration mode.
● If you exit the MSTP configuration mode with the end command, you return to the Privileged
EXEC mode.
6.3.6.1

instance

Description
With this command, you assign a range of VLANs to an MST instance.
Requirement
You are in the MSTP configuration mode.
The command prompt is as follows:
cli(config-mst)#
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06
Network structures
6.3 Spanning Tree
259