Snmp Targetaddr - Siemens SCALANCE XC-200 Configuration Manual

Result
The details of the SNMP notifications are deleted.
Further notes
You change the details of an SNMP group with the snmp notify command.
You display the configured SNMP notifications with the show snmp notif command.
You display the configured SNMP target addresses with the show snmp targetaddr
command.
7.5.2.14

snmp targetaddr

Description
With this command, you configure the SNMP target address.
Requirement
● The SNMP target parameters are configured.
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
snmp targetaddr <TargetAddressName> param <ParamName>
{ipv4<IPAddress>}
The parameters have the following meaning:
Parameter
TargetAddressName
param
ParamName
ipv4
IPAddress
timeout
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06
[timeout <Seconds(1-1500)] [retries <RetryCount(1-3)]
[taglist <TagIdentifier | none>]
[port <integer (1-65535)>]
Description
Name of the target address
Keyword for the parameter name
Name of the destination address or
the designation of the parameter
name
Keyword for an IPv4 address
Value for an IPv4 unicast address
Keyword for the time the SNMP agent
waits for a response before it repeats
the inform request message
[{volatile | nonvolatile}]
Range of values
max. 32 characters
-
max. 32 characters
-
Enter a valid IPv4 unicast address.
-
Network protocols
7.5 SNMP
341