Passive Listening; The "Show" Commands; Show Passive-Listening; Commands In The Global Configuration Mode - Siemens SCALANCE XC-200 Configuration Manual

6.4

Passive Listening

This section describes commands of the passive listening function.
If you enable passive listening, the IE switch forwards (R)STP configuration frames (BPDUs)
transparently even when (R)STP is disabled for it. The IE switch also reacts to topology change
frames. When the IE switch receives a TC frame, it deletes the MAC address table.
6.4.1

The "show" commands

This section describes commands with which you display various settings.
6.4.1.1

show passive-listening

Description
This command shows whether or not "passive listening" is enabled.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
show passive-listening
Result
disabled is displayed if "passive listening" is disabled. If "passive listening" is enabled,
enabled is displayed.
6.4.2

Commands in the global configuration mode

This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can be
found in the relevant sections.
You exit the Global configuration mode with the end or exit command and are then in the
Privileged EXEC mode again.
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06
Network structures
6.4 Passive Listening
265