The parameter has the following meaning:
Parameter
gateway
Result
The entry is configured.
Further notes
You delete the default gateway with the no ip gateway command.
You show the default gateway with the show ip gateway command.
7.1.2.2
no ip gateway
Description
With this command, you delete the default gateway.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
no ip gateway <gateway>
The parameter has the following meaning:
Parameter
gateway
Result
The entry is deleted.
Further notes
You configure the default gateway with the ip gateway command.
You show the default gateway with the show ip gateway command.
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06
Description
Specifies the IP address of the gateway
Description
Specifies the IP address of the gateway.
Network protocols
7.1 IPv4 protocol
Range of values
enter a valid IP address
Range of values
Specify a valid IP address.
273