Switchport Acceptable-Frame-Type - Siemens SCALANCE XC-200 Configuration Manual

Network structures
6.1 VLAN
Syntax
Call the command without parameter assignment:
no private-vlan mapping
Result
The IP interface of the primary PVLAN cannot be reached from the selected secondary
PVLANs.
Further notes
You configure a link between secondary PVLANs and the IP interface of the primary PVLAN
with the command private-vlan mapping.
You display this setting with the show interfaces command with the private-vlan
mapping parameter.
6.1.3.3

switchport acceptable-frame-type

Description
With this command, you configure which types of frames are accepted.
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
switchport acceptable-frame-type{all|tagged|
untaggedAndPrioritytagged}
The parameters have the following meaning:
Parameter
all
tagged
untaggedAndPriori
tytagged
180
Description
All frames are accepted.
The device discards all untagged
frames. The device forwards all tagged
frames.
The device discards all tagged frames.
The device forwards all untagged
frames and frames with a priority.
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Range of values / note
Default
On a ring port only the parameter
"all" is supported.
-
-
Configuration Manual, 07/2017, C79000-G8976-C361-06