Commands In The Interface Configuration Mode (Vlan Bridge); Private-Vlan Mapping - Siemens SCALANCE XC-200 Configuration Manual

Network structures
6.1 VLAN
The parameters have the following meaning:
Parameter
vlan-id
vlan-id
Enter a space before and after the hyphen, e.g. vlan range 5 - 10.
For information on names of addresses and interfaces, refer to the section "Addresses and
interface names (Page 36)".
Result
The command prompt is as follows:
CLI(config-vlan-range)#
Configuration commands you enter with this command prompt apply to all selected VLANs.
Further notes
With the command exit, you return to the Global configuration mode.
6.1.3

Commands in the Interface configuration mode (VLAN Bridge)

This section describes commands that you can call up in the interface configuration mode.
Depending on the Interface selected, various command sets are available.
In the Global configuration mode, enter the interface command to change to this mode.
Commands relating to other topics that can be called in the interface configuration mode can
be found in the relevant sections.
● If you exit the Interface configuration mode with the exit command, you return to the Global
configuration mode.
● If you exit the Interface configuration mode with the end command, you return to the
Privileged EXEC mode.
6.1.3.1

private-vlan mapping

Description
With this command you specify from which secondary PVLANs the IP interface of the primary
PVLAN will be reachable.
178
Description
Number of the addressed VLAN
Number of the addressed VLAN
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Range of values / note
1 ... 4094
2 ... 4094
Configuration Manual, 07/2017, C79000-G8976-C361-06