Security and authentication
11.3 Management Access Control List
11.3
Management Access Control List
This section describes the commands relevant for working with the management access
control list.
11.3.1
The "show" commands
This section describes commands with which you display various settings.
11.3.1.1
show authorized-managers
Description
This command shows the information about the configuration of the authorized managers.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
show authorized-managers[ip-source<ip-address>]
The parameters have the following meaning:
Parameter
ip-source
ip-address
For information on identifiers of addresses and interfaces, refer to the section "Addresses and
interface names (Page 36)".
Result
The information about the configuration of the authorized managers is displayed.
11.3.2
Commands in the Global configuration mode
This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the configure terminal command to change to this mode.
512
Description
Keyword for the network or host address -
Value for an IP address
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Range of values / note
specify a valid IP address
Configuration Manual, 07/2017, C79000-G8976-C361-06