Show Device Information; Show Environmental Temperature - Siemens SCALANCE XC-200 Configuration Manual

Syntax
Call the command without parameters:
show coordinates
Result
The system coordinates are displayed.
3.1.1.3

show device information

Description
This command shows information about the device.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameters:
show device information
Result
The information about the device is displayed.
3.1.1.4

show environmental temperature

Description
This command shows the temperature values of internal and external modules of the device.
The modules are only shown if they make temperature information available.
If the temperature value falls below or exceeds the displayed threshold values, the status
changes accordingly. With the event config command, you can configure that you are
informed of the status change by a message.
Requirement
You are in the Privileged EXEC mode.
The command prompt is as follows:
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06
Configuration
3.1 System
49